Allied Telesis Network Card AT MC110 Series User Manual

Datasheet | Media Converters  
MC11x Series  
Fast Ethernet Media Converters  
AT-MC115XL  
MissingLink™  
Key Features  
10/100TX to 10FL/100SX 850nm fiber  
ST media converter  
The MissingLink feature allows accurate  
reporting to network management systems as  
well as allowing devices with redundant link  
capability to be inter-connected with these  
media converters, failure in one fiber link will be  
signalled to the switch, allowing the second link  
to become active.  
10/100TX copper port  
AT-MC116XL  
10/100TX to 10FL/100SX 850nm fiber  
SC media converter  
10/100SX fiber port  
Half and full-duplex operation  
Transparent to IEEE 802.1Q packets  
Fiber Connections  
Rack-mountable using optional AT-MCR12,  
AT-TRAY4 or AT- TRAY1 chassis  
The Allied Telesis range of 850nm fiber Fast  
Ethernet media converters allows users to  
extend the size of UTP networks with the use  
of fiber cabling. Converting between 10T and  
10FL or 100TX and 100SX fiber quickly and  
reliably, the AT-MC115XL and AT-MC116XL  
address the growing demand for a low-cost  
solution for fiber installations of up to 300  
meters for 100SX and up to 2km for 10FL.To  
maximize flexibility, the converters are available  
in ST (AT-MC115XL) and SC (AT-MC116XL)  
fiber connector styles.  
Simple Installation  
All the media converters with a UTP  
MDI/MDI-X  
MissingLink  
Link test  
connection feature an internal MDI/MDI-X  
switch, allowing the converter to be connected  
to either a PC, hub or switch with a simple UTP  
cable.The media converters also allow the  
installer to test the integrity of fiber connection,  
by forcing the converters to communicate over  
the fiber cable.This link test feature allows  
installers to check for cable faults without the  
need for expensive fiber optic test equipment.  
Auto-negotiation  
Wall-mountable using optional AT-WLMT  
bracket  
Auto-Negotiation  
Standalone or Rack-mountable  
Each media converter is powered by an  
external power supply unit for use in standalone  
applications.Where multiple media converters  
are being used, up to 12 devices can be  
inserted into a low-cost rack-mount chassis,  
allowing all the converters to be powered by a  
single internal power supply. In critical  
applications, a second load sharing internal  
power supply can be installed into the rack-  
mount chassis.  
The AT-MC115XL and AT-MC116XL auto-  
negotiate during the link-up phase of the  
connection to set the speed (10/100) and  
operation mode (full or half-duplex).When  
connecting media converters to auto-  
negotiating Fast Ethernet switches, these media  
converters will automatically connect the link in  
either full or half-duplex mode, allowing the link  
to be established with the greatest bandwidth.  
Allied Telesis  
 

3Com Network Card WL 601 User Manual
Acer Flat Panel Television LCD S243HL User Manual
Aiphone Intercom System JF User Manual
Aiwa CD Player NSX V9000 User Manual
Altec Lansing MP3 Docking Station Octiv Air User Manual
Amana Clothes Dryer LE2500 User Manual
Audiovox Car Satellite Radio System SIR CK3 User Manual
Audiovox Remote Starter 128 8114 User Manual
Audiovox Speaker IPD SBBT User Manual
Avocent Power Supply PM User Manual